Desoldering Wick CP3015 3MM 1.5M شيلد لحام

Desoldering Wick CP3015 3MM 1.5M شيلد لحام is a professional-grade solder braid designed to remove excess solder and clean solder joints during PCB rework and repair. The braid is supplied in a 1.5‑meter length and 3 mm width, providing a convenient balance between reach and control for fine to moderate desoldering tasks.

Key features include a tightly woven braid that wicks molten solder efficiently and consistent flux impregnation to promote reliable solder absorption. Its 3 mm width is suitable for removing solder from component leads, through-hole pads, surface-mount pads, and small traces without excessive spreading of solder or damage to adjacent components when used with proper technique.

Typical applications: circuit board repair, component replacement, solder joint cleanup, and hobby electronics rework. The braid works with leaded and lead‑free solders and is compatible with standard soldering irons and hot air stations when used as part of established desoldering procedures.

Usage tips: cut or unwind a fresh length of braid, place it over the solder to be removed, heat the braid with the soldering iron tip until solder is drawn into the braid, then lift the iron and braid together. Replace the used section of braid as it becomes saturated to maintain effectiveness. Avoid prolonged heat exposure to pads and components and allow the board to cool between cycles.

Storage and handling: keep the braid in a dry, dust‑free environment and away from direct sunlight. Dispose of used braid in accordance with local waste regulations. This product is supplied as shown and labeled; refer to your workplace safety guidelines for handling flux‑containing materials and for appropriate personal protective equipment.